Mimk-082 ((hot))

| Mode | Description | When to use | |------|-------------|-------------| | | Minimal power consumption, retains settings. | When the unit is idle for long periods. | | Continuous | Streams data at the configured sample rate. | Routine monitoring or data logging. | | Triggered | Captures data only when a threshold is crossed. | Event‑driven testing, fault detection. | | Calibration | Runs internal self‑test and calibration routines. | Prior to critical measurements or after hardware changes. |

| Task | Frequency | Procedure | |------|-----------|-----------| | | Monthly | Power off → use a soft, lint‑free brush or canned air (30 cm distance) to clear vents. | | Connector inspection | Quarterly | Check for oxidation, tighten loose screws, re‑apply contact cleaner if needed. | | Firmware update | As released | Download the latest firmware from the vendor site → use the utility’s “Update Firmware” button. | | Battery replacement (if applicable) | Every 2 years | Open the rear panel, replace the Li‑ion cell with an identical part, observe polarity. | | Full calibration | Annually or after major repairs | Follow Section 8. | MIMK-082