Factory Reset — Zkteco Ua300

After completing the , your device is a blank slate. Here is what you need to do immediately:

If you are locked out because you forgot the admin password, you can use the tamper switch located on the back of the device: the device. Locate the Tamper Switch (a small button or magnet sensor on the back). the device while holding down the tamper switch. zkteco ua300 factory reset

: Open the software and ensure the device is "Connected" via its IP address (Default: 192.168.1.201 ). After completing the , your device is a blank slate

| Feature | UA300 | K30/K40 (Similar) | K20/M20 (Touch) | | :--- | :--- | :--- | :--- | | | No | No | Yes (in System Settings) | | Button Combo Required | Yes (OK + Power) | Yes (ESC + Power) | No | | Retains IP after Reset | No (resets to default) | No | No (resets to default) | | User Data Recovery | Impossible | Impossible | Impossible | the device while holding down the tamper switch

"One last try," she whispered. She knew that if she could trigger the factory default settings, she would lose the user data, but at least the doors would open again. Following instructions for similar standalone terminals